Veto Pro Pack TECH-XXL

EXTRA LARGE TECH INSTALLER’S TOOL BAG Optimized for technicians and installers, the TECH-XXL’s 25 vertical interior pockets are capable of storing a large assortment of tall hand tools for sheet metal or mechanical work. The V-SWAP™ system enables reconfiguring of the interior vertical pockets and/or the addition of other Veto pocket accessories. The back bay of the TECH-XXL provides ample volume to store 3-4 cordless tools, extra batteries and even a charger. The XXL base is ideal for attic install and duct work, as the 25″/63cm base easily spans standard joist spacing.  Additional panels may be purchased separately PRODUCT SPECIFICATIONS: Height (H): 13" (33cm) Width (W): 26" (66cm) Depth (D): 10" (25.5cm) Handle Height (HH): 20.5in/52cm Weight (empty):  11.5 lbs/5 kg Internal Volume: 2012in3/33L Max Payload: 50lbs/23kg MAXIMIZED TOOL STORAGE CAPACITY: Extra large front & back zippered storage bays to keep tools safe & secure V-SWAP™ removable & customizable tool pocket panel system with alternate tool panels available & sold separately 18 exterior pockets of varying sizes Up to 25 interior vertical tool pockets of varying sizes available on the front Extra large open bulk storage area in back bay for larger tools & equipment Waterproof Polypropylene plastic base for moisture and abrasion protection Metal YKK® locking zippers 8” Electrical tape strap Interior gray pockets for better visibility 56" Extra Padded Shoulder Strap with Clip  Additional Information   VETO PRO PAC TOOL BAGS PRODUCT CARE AND MAINTENANCE Keep the Zippers Clean & Lubricated Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant. Protect the Zippers From Sharp Objects and/or Excessive Heat Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils. Don’t Overstuff the Bag Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed… proceed with caution!